In modern wettability characterization, it is often pointed out that measurement of static contact angle is not enough due to their inability to present real properties of the surface. Most typically measurement of advancing and receding contact angle is encouraged. In our previous post, we have already discussed the advancing contact angle while in this post we are concentrating on receding one.
What is a receding contact angle?
A Receding contact angle is the lowest possible contact angle on a given surface. The receding angle is measured on a previously wetted surface.
The receding contact angles are measured when the liquid front is receding over the surface to be measured. This can be done in different ways with an optical tensiometer such astilting the sampleordecreasing the volume of the dropletwhile at the same time recording the contact angle values. Receding contact angles are also measured with force tensiometers with theWilhelmy plate methodby withdrawing the sample from the liquid and measuring a force by extremely sensitive balance.
The receding contact angle rises from the polar nature of the solid
On a chemically heterogenous surface, the receding angle is more sensitive to the high-energy components i.e. polar parts of the surface. If the receding water contact angle is measured on a primarily hydrophilic surface, the hydrophobic inclusions from the surface will not affect the receding contact angle value until they cover a significant portion of the hydrophilic surface. On a hydrophobic surface, the receding water contact angle quickly decreases to a lower value even if the surface is only slightly covered with the hydrophilic inclusions. The value is also not much affected even with an increasing fraction of the hydrophilic components.
Surface roughness affects the receding angle
Receding contact angles are easily affected by surface roughness. If the advancing contact angle is below 70 and the surface is rough, close to zero receding contact angles will likely be measured on that surface. This means that on these kinds of surfaces, the receding angle is not able to give much of an insight into surface chemical composition but can be used to evaluate the level of roughness.
To characterize superhydrophobic surfaces, the receding angle is more meaningful as it will also evaluate the roll-of-angle. The requirement for a superhydrophobic surface is higher than a 150-degree contact angle and low roll of angle. Over a 150-degree receding angle will alone guarantee these requirements.
